Aby wykonać procedurę RESETOWANIA, gdy samochód stoi, a wyłącznik zapłonu jest w położeniu MAR, należy w Menu głównym wykonać następujące czynności:wybrać po Select the vehicle settings icon , and then press confirmation button. Select “Maintenance System”. Select “TPMS”, then press and hold the confirmation button on the steering wheel. When initialization completes, a message is displayed on the multi-information display and the tire pressure warning light illuminates. chappy123. 54 posts · Joined 2012. #19 · Sep 24, 2013. I just had the TPMS System Unavailable light and message come on in my 2012 Rosso Sport. I have the GTR 17" rims with the proper sensors I got from 500 Madness, and for the last two months it has worked fine. Here's how to reset the Ford tire pressure sensor: Push the brake pedal down with your foot, wait three seconds, then take your foot off the brake. Turn the start button on and off three times. If the ignition requires a key, switch the ignition to On with the key. Do not start the engine. End with the On mode on the third push. Step 3: Turn on the Ignition. Once you have located the TPMS reset button, turn on the ignition without starting the engine. Make sure all doors are closed during this process. You should see various warning lights illuminate on the dashboard. The purpose of the TPMS (Tire Pressure Monitoring System) on FIAT is to alert you when tire pressure is too low and could to create unsafe driving conditions. If the light is illuminated, it means your tires could be underinflated, which can lead to undue tire wear and possible tire failure. It’s important to understand the importance of Tyre pressure init. at stop. The message is displayed during driving. If you want to reset the pressure of the four tyres, stop the vehicle. 1. Tyre pressure init. long press. To reset the pressure of the four tyres, with the vehicle stopped, press and hold the 5 OK switch to launch resetting until the “If pressure OK [hold on]” message is If this is the case, then modify steps 4 and 6 as noted. 1. Inflate all tires to pressure listed on vehicle placard. 2. Leave the driver’s door open during the relearn procedure. 3. With the vehicle OFF, press and release the brake pedal. 4. Press the IGNITION BUTTON 5 times (NOTE: 8 times if 2x-to-RUN). IeQZDN.